LG 37LC50CB Service Manual page 13

1) Select HCS12
2) Target Frequency Settings :
A. Checking the factor -> Use Specified Target Frequency
..., Unsecure target....
B. Insert Target Bus Frequency -> 7372800
3) Specify Algorithm: 9S12dt128_128k .12P
4) Specify S Record: select download file.
5) Checking factor: Erase Device, Blank Check Device,
Program Device, Verify Device
* Notice!
Don't check other checking boxes. You must follow fig.
6) Push the 'Save Image to Cyclone PRO' button, files
transfer from PC to the Download JIG.
PC -> Download Jig
5. Select method of Module type
5.1 Setting up like figure
(Setting: Press ADJ Key in the Adjust remocon.
Select "System Control 3" by using
A
(ENTER)
Using Adjust remocon, select module)
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
D E
/ (CH+/-) key, and press
Before ADC Calibration, should be executed the "Module type
selection".
6. Color Balance adjustment.
6.1 Auto AV (CVBS) Color Balance
6.1.1 Required Equipment
- Remote controller for adjustment
- AV Pattern Generator: 802F Pattern Generator, Master
(MSPG-925FS), etc
(Which has NTSC-J Composite Video format output with
standard (1.0 Vpp) See Fig. 1)
- It is very import to use correct adjustment pattern like
Fig.1.
6.1.2 Method of Auto AV (CVBS) Color Balance
1) Input the NTSC-J Composite Video (Fig.1.) into video
input.
=> MSPG-925FS Model No: 207 / Pattern No: 65 / NTSC-J
2) Set the EZ Picture to Daylight mode in Video menu.
3) Press INSTART key on R/C for adjustment.
G
4) Press the (Vol. +) key operate to set, then it becomes
automatically.
5) Auto-RGB OK means completed adjustment.
* When adjust main picture, sub picture is included.
<Fig.1> Auto AV (CVBS) Color Balance Test Pattern
Auto Color Balance (Hex)
Auto-RGB
Source
Red Offset1
Green Offset1
Blue Offset1
Red Offset2
Green Offset2
Blue Offset2
Red Gain
Green Gain
Blue Gain
Reset
- 13 -
G To Set
Main
102
0C6
0DA
3F
3F
3F
072
070
07B
G To Set
Default Value on OSD
LGE Internal Use Only