Costway HW54237 Instructions Manual

Costway HW54237 Instructions Manual

16” double blade oscillation pedestal fan

Advertisement

Quick Links

16" DOUBLE BLADE OSCILLATION PEDESTAL FAN
MODEL#HW54237
Please read these instructions carefully and keep for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HW54237 and is the answer not in the manual?

Questions and answers

Summary of Contents for Costway HW54237

  • Page 1 16” DOUBLE BLADE OSCILLATION PEDESTAL FAN MODEL#HW54237 Please read these instructions carefully and keep for future reference.
  • Page 2: Package Contents

    PACKAGE CONTENTS Part Description Quantity Front Grill Plastic Ring Spinner Small Blade Main Blade Plastic Nut Read Grill Motor Housing Axis Motor Housing Manual Control Panel Washer L Screw Free neck Screw of Control Panel Adjustable Pole Adjustable Pole Tightening Knob Pillar Base Plug...
  • Page 3: Safety Information

    SAFETY INFORMATION Signal Word Definitions NOTE: These are general definitions only; all may not pertain to the specific product purchased. DANGER – Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. Usage of this signal word is limited to the most extreme situations. WARNING –...
  • Page 4 Preparation Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts. Estimated Assembly Time: 30 minutes Tools Required for Assembly: Phillips Screwdriver (not included), ASSEMBLY...
  • Page 5: Operation

    Front Grill and Rear Grill up before operating. OPERATION Remote Control: Press this key, it will be in wind speed state, the relative indicator light will be on. Press this key again , the following diagram shows the order of the wind flow. 1(Low) 2(MED.) 3(HIGH)
  • Page 6: Maintenance

    Attention: The remote control must face to the receiver The using range of the remote control must be within 7 meters away from receiver. If the remote control isn’t faced to the receiver, its using range will be narrowed. If this fan is used in the room with operating high-power machines, the remote control may be out of order.
  • Page 7: Troubleshooting

    .• WARNING: Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse. Do not replace atta chment plug. Discard product if the attachment plug is damaged. TROUBLESHOOTING WORK SHOULD BE DONE BY A FACTORY AUTHORIZED SERVICE CENTER. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1.

Table of Contents