Kalamazoo K-SMOKE-36 Use And Care Manual page 49

Built-in Smoker Cutout Dimensions
For installation into masonry or other non-combustible surrounds, see cutout dimensions below.
IMPORTANT INSTALLATION NOTES:
ƒ
The space between the right side of the upper structure that protrudes through the countertop
and the right side of the main cabinet body is only one inch wide. This is not enough for a typical
countertop section. If installing the smoker at the right end of a cabinetry or masonry run, additional
space and support will be needed to the right end of the smoker to support an adequate minimum
countertop section. We recommend adding at least 4 inches to the right of the cabinet. This is not an
issue on the left side of the smoker cabinet.
ƒ
Do not install the smoker cabinet immediately adjacent to the left side of a grill. A minimum of 4 inches
is recommended between a grill on the right and the smoker cabinet on the left. This also applies to any
other countertop protrusions that might be too close to the right side of the smoker cabinet.
ƒ
Warning: Do not leave the built-in smoker outside without the protection of an installed countertop. If
the smoker will be exposed to rain prior to installing the countertop, please keep it covered.
1.800.868.1699 47