Yamaha AVENTAGE RX-A1080BL Owner's Manual page 124

■ Video Mode
Configures the video signal processing settings.
Video Mode
Enables/disables the video signal processing (resolution and aspect ratio).
Settings
Direct Disables the video signal processing.
Enables the video signal processing.
Processing
Select a resolution and an aspect ratio in "Resolution" and "Aspect".
X
• When "Video Mode" is set to "Direct", the unit transmits video signals with the least circuitry in order to reduce
video output delay.
• When "Video Mode" is set to "Processing" and the resolution is being converted, short messages are not
displayed on the TV screen.
Resolution
Selects a resolution to output HDMI video signals when "Video Mode" is set to "Processing".
Settings
Through Does not convert the resolution.
Auto Selects a resolution automatically in accordance with TV resolution.
Output video signals with a selected resolution.
480p/576p, 720p,
1080i, 1080p, 4K
(Only the resolutions supported by your TV are selectable.)
X
If you need to select a resolution that is not supported by your TV, set "MONITOR CHECK" (p.139) in the
"ADVANCED SETUP" menu to "SKIP" and try again. (Note that the output video may not be displayed on your TV
normally.)
Aspect
Selects an aspect ratio to output HDMI video signals when "Video Mode" is set to "Processing".
Settings
Through Does not convert the aspect ratio.
Outputs 4:3 video signals to a 16:9 TV with black bands on either side of the
16:9 Normal
screen.
X
This setting functions only when 480i/576i or 480p/576p signals are converted into 720p, 1080i, 1080p, or 2160p
(4K) signals.
■ HDMI Control
Configures the HDMI control settings.
HDMI Control
Enables/disables HDMI Control (p.162).
Settings
Off Disables HDMI Control.
Enables HDMI Control.
On
Configure the settings in "TV Audio Input", "ARC" and "Standby Sync".
Y
To use HDMI control, you need to perform the HDMI Control link setup (p.162) after connecting HDMI
Control-compatible devices.
TV Audio Input
Selects an audio input jack of the unit to be used for TV audio input when "HDMI Control" is set
to "On". The unit's input source automatically switches to TV audio when the TV input is
switched to its built-in tuner.
Settings
AUDIO 1-3
Y
When using ARC to input TV audio to the unit, you cannot use the input jacks selected here for connecting an
external device because the input will be used for TV audio input.
124
En