Aquasafe; Electrical Connection; Initial Use - Beko DIS25010 User Manual

Installation

Aquasafe+

(depends on model)
The Aquasafe+ system protects against
water leaks that may occur at the hose inlet.
Water contact with the valve box of the
system must be avoided to prevent damage
to the electrical system. If the Aquasafe+
system is damaged, unplug the product and
call the Authorised Service Agent.
A
As the hose set contains
electrical connections and
assemblies, never shorten
or lengthen the hose with
extension hoses.

Electrical connection

Connect the product to a grounded outlet
protected by a fuse complying with the
values in the "Technical specifications" table.
The manufacturer shall not be liable for any
damages that will arise when the product is
used without grounding in accordance with
the local regulations.
Connection must comply with national
•
regulations.
Power cable plug must be within easy
•
reach after installation.
B
Unplug the product after the
washing programme is over.
Dishwasher / User's Manual
The voltage and allowed fuse or breaker
•
protection are specified in the "Technical
specifications" section. If the current
value of the fuse or breaker in the house
is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
The specified voltage must be equal to
•
your mains voltage.
Do not make connections via extension
•
cables or multi-plugs.
B
Damaged power cables must
be replaced by the Authorised
Service Agent.
B
If your dishwasher is equipped
with internal illumination, lamp
should only be replaced by the
Authorised Service Agent in case
of failures that may occur on the
lamp.
B
If the product has a failure, it
should not be operated unless
it is repaired by the Authorised
Service Agent! There is the risk
of electric shock!

Initial use

Before starting to use the product, make sure
that all preparations are made in accordance
with the instructions in sections "Important
safety instructions" and "Installation".
To prepare the product to do the dishes,
•
perform first operation in the shortest
programme with detergent while the
machine is empty. During the initial use,
fill the salt reservoir with 1 litre of water
prior to filling it with salt.
A
There might be a small amount
of water left in the product after
factory quality control tests. This
has no harm on the product.
11 / 40 EN