Rough-In Dimensions - Frigidaire FTF1240FS2 Installation Instructions Manual

5. Carefully move the washer to within 4 feet (122cm) of the final
location.
6. Remove the following from the back side of the washer:
3 bolt
3 yellow plastic spacers,
2 or 3 metal "P" clamps.
7. Remove the service panel from the front of the washer.
8. Remove the 4 nuts and 6 large washers that attach the 2 yellow
shipping braces to the drum and the base. Lift up on the drum
and remove the braces (a yellow ribbon surrounds the items to
be removed). These braces must be removed to allow the power
` supply cord to be released from the shipping ring.
UNDER COUNTER INSTALLATION
If an under counter* installation is desired, the washer MUST have a top sheet kit installed, P/N 131445600. Kit is available from an
authorized parts distributor. *Custom sized countertop is required.
9. Remove the large styrofoam block located under the drum. Lift up
on the drum, tilt the base of the foam block inwards toward the
rear of the washer until free, then pull it out.
10. Remove and discard the yellow ribbon and label from the front of
the washer.
11. From the rear of the washer, carefully pull out the power supply
cordthrough the hole in the backsheet.
12. Replace the service panel and screws.
NOTE: If the washer is to be transported at a later date, the shipping
support hardware must be reinstalled to prevent shipping damage.
Retain the hardware in the plastic bag provided
BOLT
SPACER
"P" CLAMP

ROUGH-IN DIMENSIONS

3
.