Table of Contents
Advertisement
Quick Links
Y
Parts Included:
FW140.08XX - 8 Wire Harness
FW140.10XX - 10 Wire Harness
!
WARNING
All electrical connections to building electrical sources must
be made by a qualified electrician according to national,
state and local electrical codes.
!
WARNING
Disconnect power before installation. Failure to do so can
cause electrical shock and personal injury.
!
WARNING
Electrically interconnected units must be mechanically
interconnected.
Tools Required:
Safety Glass
Z
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Canvas Office Landscape
Entry Installation and Disassembly for Recycling Instructions
A
Power Entry Harness
Beam Internal Direct Connect Power
®
Part no. 1b6pd2 rev B.
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HermanMiller Canvas Office Landscape FW140.08 Series
Summary of Contents for HermanMiller Canvas Office Landscape FW140.08 Series
- Page 1 Canvas Office Landscape Beam Internal Direct Connect Power ® Entry Installation and Disassembly for Recycling Instructions Parts Included: Power Entry Harness FW140.08XX - 8 Wire Harness FW140.10XX - 10 Wire Harness WARNING All electrical connections to building electrical sources must be made by a qualified electrician according to national, state and local electrical codes.
- Page 2 FW140.08XX – 8 WIRE HARNESS WIRING DIAGRAMS 4-2-2 4 HOTS, 2 NEUTRALS, 2 GROUNDS NOTE: CIRCUITS 1,2,3,4 CORRESPOND TO CIRCUITS (DUPLEX RECEPTACLES) A, B, C, D ALLOWABLE CIRCUIT COMBINATIONS: 1,2,3,4 ; 1,2,3 ,4 ; 1, 2 ,3 ,4 NOTE: CIRCUITS 1, 3, 4 CORRESPOND TO CIRCUITS (DUPLEX RECEPTACLES) A, C, D ALLOWABLE CIRCUIT COMBINATIONS: CIRCUITS 1, 3, 4 ;...
- Page 3 FW140.10XX – 10 WIRE HARNESS WIRING DIAGRAMS 4-4-2 4 HOTS, 4 NEUTRALS, 2 GROUNDS ALLOWABLE CIRCUIT COMBINATIONS: 1,2,3,4 ; 1,2,3 ,4 ; 1, 2 ,3 ,4 ; 1,2,3,4,1 ,2 ,3 ,4 ALLOWABLE CIRCUIT COMBINATIONS: CIRCUITS 1,2, 3, 4 ; 1, 2, 3,4 ; OR 1, 2, 3 ,4 Part no.
- Page 4 Power Harness Spring Tab Bracket Hook Mounting Lug Receptacle Bracket Connector Connector Block Mid-Run Support Installation: Power Entry Shroud 1. Place Harness Body into Bracket to one side of Bracket Hooks at left side of Connector Block. 2. Slide Connector in Receptacle into Power Harness. Press further until Mounting Lug fully engages into Bracket Hook and Spring Tab seats onto Harness Body.
- Page 5 Disassembly and Recycling: Materials Identification and Segregation: Where possible, plastic components are marked with ASTM recycling codes. Use these codes to identify material type for recycling. Non marked components should be treated as mixed plastic. Ferrous metals can be identified using a small magnet for recycling.
Need help?
Do you have a question about the Canvas Office Landscape FW140.08 Series and is the answer not in the manual?
Questions and answers