HermanMiller Canvas Channel 90 Installation And Disassembly For Recycling Instructions

HermanMiller
Canvas Channel 90° Connector
Installation and Disassembly for
Recycling Instructions
How to assemble and reassemble your
90° Connector
Tools Required
Ratchet 9/16" Socket
Assembly Instructions
Step 1
1.1 Align 2, 3 or 4 wall frames.
1.2 Connect frames to Top Connector Tube if using the FZ121 product using
Screws and Washers at top hole location. For 3 way connection make sure
Top Connector Tube open side faces outward. Do not tighten screws.
Open
Side
Hole
HermanMiller for Canvas Channel 90° Connector Installation Instructions
9/16" Torque
Wrench Wrench
Frame
Connector Tube
Slot
Parts Included
Connector Tube(2)
Light Seal
FZ121.2(1)
FZ121.3(2)
FZ121.4(4)
Notice:
Do not tighten screws until at least 2 frames are completely connected.
Safety Glass
Notice:
Make certain that fasteners are torqued to the specified values.
Step 2
For 22" High Products when used with Structural Foot:
2.1 Assemble Connector Tube to frames at slot location as shown below
with Screws and Washers. Tighten screws. Continue to Step 3.
Important: Torque screws to 200 in-lbs. Start with top connector
tube, then bottom.
1
3/8-16 Hex Head
Cap Screw
Use the bottom slot to attach
1BKRBR rev B
Washer
Hardware Pack
FZ121.2(4)
FZ121.3(6)
FZ121.4(8)
Washer
Replacement Instructions