Advertisement
1
INSTALLATION
WARNING
Level both appliance and pedestal after the
installation or service.
Make sure that all feet are stable and resting on the
floor/pedestal.
When pushing down the edges of the appliance top
plate diagonally, it should not move at all.
(Check all directions.)
After installation/servicing, operate the appliance to
ensure it functions correctly.
D D R R Y Y E E R R I I N N S S T T A A L L L L A A T T I I O O N N
1
Remove pedestal, installation hardware, and
instructions from the shipping carton.
2
Position dryer on top of the pedestal.
NOTE :
Because of the weight of the dryer,
two or more people may be needed.
NOTE :
If dryer was previously installed, uninstall
it as follows:
1) Unplug power supply cord.
2) Turn off the gas supply (Gas dryer).
3) Pull the dryer away from the wall enough to
loosen the vent clamp. Loosen the clamp and
carefully remove the exhaust vent from the
dryer exhaust outlet.
3
Remove the paper from the
bracket.
4
5
6
for washer/
combo
for dryer
for dryer
for washer/
7
combo
-
3
-
Attach the double-faced tape of the bracket to the
dryer as shown so the bent parts of the brackets
align with the edge and can be attached to the
pedestal with screws.
NOTE :
Attach the lower side first.
Be sure to press the adhesive parts of the brackets
firmly to the appliance.
Install the eight (8) screws (supplied) to attach the
brackets to the pedestal.
Move the dryer to the desired place.
NOTE :
The appliance and pedestal assembly
must be placed on a solid and level floor
for proper operation. Adjust the legs of the
appliance and pedestal by turning with a
wrench. Then, adjust the lock unt toward
the pedestal while holding the pedestal leg
using a wrench.
Advertisement
