Table of Contents
Advertisement
Water is not flowing in.
Intense vibrations during
spinning.
Washer-dryer fills with
water and continuously
Drains it away.
No water can be seen in the
drum.
Water leaks from the bottom
of the appliance.
Foam escapes from
detergent drawer.
Several attempts to start
spinning.
Washing is not spun
properly.
Washing results not
satisfactory.
Detergent residues on the
washing.
Grey residues on the
washing.
Programme terminated
unexpectedly.
Spinning during drying
The mains plug is not correctly
plugged in.
The door is not properly closed.
The tap is not turned on.
The filter in the water supply hose is
blocked.
The water supply hose is pinched or
kinked.
The washer-dryer is not correctly
levelled.
The transport safety bolts have not
been removed.
Drain hose fitted too low.
Not a fault.
Supply hose screw connection is
leaking.
Drain hose is leaking.
Too much detergent has been used.
Not a fault.
The unbalanced load detection system
attempts to redistribute an unbalanced
load by starting to spin several times.
Large items of laundry are not evenly
distributed in the drum. The spin speed
is automatically reduced for safety
reasons.
Uncleaned areas worse than expected. Select a suitable programme, e.g. a
Too little or incorrect detergent used.
Maximum load exceeded.
Some phosphate-free detergents
contain water-insoluble residues which
appear on washing as light specks.
Soiling caused by ointments, grease or
oil.
The A (Start/Pause) button was
selected accidentally.
No fault
Plug in the mains plug correctly.
Close the door.
Turn on the tap.
Clean the filter in the water supply hose
–> page 20.
Check the water inlet hose.
Level the washer-dryer –> page 27.
Remove the transport safety bolts
–> page 26.
Fit the Drain hose correctly
–> page 28.
During certain programmes the water
level is below the visible range.
Tighten the screw connection.
Have the Drain hose replaced by the
after-sales service.
Only use detergent which is correct for
textiles, and suitable for use in
automatic washing machines.
Make sure that you use the correct
dosage.
Always wash large and small items
together.
Always wash large and small items
together.
programme with Pre-wash.
Pretreat stains if necessary.
Use the correct dosage of a suitable
detergent, in accordance with the
manufacturer's instructions.
Select the load appropriate for the
programme.
Rinse the laundry again or change to
using liquid detergent. Brush the
laundry after it has dried.
Wash the laundry using the maximum
detergent dosage and the maximum
permissible temperature – see the
care label.
Press the button again to restart the
programme.
"Thermo spin", which is for energy-effi-
cient drying, starts after a drying time
of approx. 10 minutes.
22
Advertisement
Table of Contents
