Panasonic CX-D3000U Operating Instructions Manual page 39

Electrical Connections
Connecting side brake (parking brake) connection lead
E
N
Caution:
G
L
For safety, be sure to ask your nearest professional installer to do this connection.
≥
I
S
H
Side brake (parking brake)
35
Foot brake
Chasiss
Connecting the Clamp Connector 5
Attach the clamp connector to the vehicle cord at a suitable position.
≥
Note that if the cord being clamped onto is too thin (0.3 mm
≥
adequate.
1
Push the end of the side brake
cord into the hole on the clamp
connector.
Place the vehicle cord into the
groove in the clamp connector.
Parking brake cord
44 44
CX-D3000U
Battery
Brake lamp 5 Clamp connector
2
Vehicle cord
Push the end of the cord
in until it touches this part.
The side brake (parking brake) switch position
varies with the car model.
For details on the exact location of the parking
brake switch in your car, contact your dealer.
Parking brake
switch
Cords connected to
the vehicle.
Side brake (parking brake)
connection lead
Of the 2 cords emerging from the parking brake switch,
connect the player's parking brake cord to the one that is
not connected to the vehicle's chassis while the brake is
in the released state.
2
While making sure that the cords
do not slip out of the clamp
connector, press the element
down with a pair of pliers.
Element
(continued)
PARKING BRAKE
(Blue/yellow stripe)
or less), the connection may not be
3
Close the cover until
it snaps shut.
Cover