Table of Contents
Advertisement
Precautions:
When installing the foam marker, it is necessary to observe a few essential rules.
• Secure the electric compressor unit in a position sheltered from stones picked up by the wheels or by the products
sprayed from the booms.
• On seeders, install the electric compressor unit sheltered from areas that are too dusty.
• Using the clamps supplied, fit the air-liquid foam nozzles at the end of the booms at a distance from the last nozzle
equal to half the distance of the spray tips. The foam must fall in an area sheltered from the nozzle, and the point
where it falls must mark the area sprayed by the boom.
• Secure the hoses to the framework with clamps, in a position protected from possible impact with the ground or
with the boom framework. At the joints of the booms, the hoses must be of such a length as to allow the booms to
open and close without damaging the hoses.
• Place the tank upright with the cap easily accessible for filling and adjusting the flow rate.
• Install the tank so it's possible to remove for periodical washing.
• The cover of the electric compressor must be easy to remove for maintenance work.
System Installation
Installing the foam marker on a sprayer
Foam Marker Installation
- 5 -
Advertisement
Table of Contents
