Table of Contents
Advertisement
12
The machine offers a wide choice of spin settings that can be selected before starting
the program. To vary the spin setting just press button (H) until the desired value is
reached (fi g. 1); if you wish to exclude the spin, press the button until "00" appears
on the display (fi g. 2).
N.B. The maximum spin speed varies according to the model and is shown
on the machine display. The maximum spin speed that can be selected
decreases with the program that is set.
Out of balance spin protection for the load:
This washing machine is equipped with a special electronic control system for the correct balancing of
the load. Before each spin, the system makes the clothes arrange themselves in the drum in the most
even way possible. In case of irregular distribution of the laundry, for safety reasons the spin speed
is reduced and in cases of the load being greatly out of balance, the spin cycle will not be effected.
DISPLAY AND DURATION OF THE WASHING CYCLE:
With each program selected with the knob (P), the corresponding spin speed and
the duration of the cycle will appear on the display; this time will decrease until it
arrives at zero when the program is fi nished and "END" appears on the display. At
this point it will be possible to take out the laundry.
N.B. In the "Cotton" programs, the duration of the washing cycle initially
shown by the display can vary, since it can be affected by various factors
such as temperature, water inlet pressure and quantity of laundry loaded
in the drum. During the wash, the machine's electronics will automatically
alter the time needed for the cycle set according to these factors, thus
achieving the best performance in the best time.
The machine is equipped with a function that enables you to delay the wash for up
to a maximum of 16 hours; each time button (I) is pressed, the display will show the
hours to wait from 1...to 16 before the machine begins the washing cycle. When key
(L) is pressed, the washing machine will wait the set number of hours and will then
automatically begin the washing cycle.
Activation of the delay is indicated by the fl ashing of the dots on the display.
After having carried out all the operations described in points 1 to 8 in the paragraph
"WASHING CYCLE" press this button and the washing machine will begin its washing
cycle. The relative LED will light up after 2-3 seconds, to indicate that the door is
locked and the program has started.
"STOP" ON THE PROGRAM SELECTOR:
The function of stop is to reset the washing machine. If for any reason during the
washing cycle you decide to vary it, or decide later to add more laundry, all you have
to do is turn the knob of the program selector to the "STOP" position, then reset the
knob to the new program chosen and press the "START" button.
Warning!! It is recommended to use this function only if strictly necessary and solely if the
program to be reset has started not more than 3 minutes previously. Before being able to open
the door after a reset, you must wait 2 minutes for it to be unlocked.
GB
USE OF THE WASHING MACHINE
VARIABLE SPIN:
DELAYED START BUTTON:
START BUTTON:
fig.1
fig.2
STOP
SM2828
Hide quick links:
Advertisement
Table of Contents
