Header/Trailer - JARLTECH CCD Series Operation Manual

All manuals and user guides at all-guides.com
Header and Trailer
Any desired header or trailer may be
programmed into the CCD scanner.
The header/trailer will be automati-
cally attached to the start/end of the
code transmitted. The maximum
length is ten digits.
The pre-set default value is for no
header nor trailer. If you wish to
program these parameters, you must
first enable reading of the Full
"ASCII" character set under the
Code 39 configuration.
The programming procedure is then
as follows:
• Scan "Program"
• Scan "Header" or "Trailer"
• Scan the desired characters in the ASCII
table (Ref:Appendix II)
• Scan "Set"
• Scan "End"
Header
Set
Program
General Parameters
Trailer
End
19