Advertisement
KORY
NBTA-0200D
CONCEALED MOUNT INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
1. Remove existing toilet and prepare installa-
tion surface.
• Shut off toilet supply and flush tank completely.
• Disconnect and remove supply line.
• If replacing a toilet remove old toilet and existing wax
ring. Cover/plug floor waste opening.
• Clean any old wax or debris from from installation area.
**NOTE: Installation surface must be clean
and level before new toilet is installed.**
• Confirm that current supply location coincides with
desired toilet location and rough-in dimensions.
Supply relocation may be necessary for proper toilet
installation.
• Position toilet template on finish floor making sure it
aligns with current waste location; tape template se-
curely to floor.
2. Using toilet installation template mark floor
screw/anchor location and drill pilot holes in
floor.
Finished Wall
**NOTE: For floors less than 1-1/2" (38 mm) thick
use a 5/32" bit. For floor thicker than 1-1/2" (38 mm)
use a 3/8" bit for anchor (required) installation.**
3. Insert screw through the plastic mounting
brackets and install securely to floor in proper
location.
4. Turn toilet on its side (please protect the
ground surface with soft material to prevent
damage to toilet), and press new wax seal
firmly around waste flange. apply a small bead
of silicone sealant around toilet base.
5. Position toilet squarely with wall and align
toilet with closet flange.
Slowly lower toilet down onto closet flange
making sure base mounting holes are aligned
with munting anchors on finished floor.
Mounting Holes
Note: Please refer
to template for
mounting hole
locations.
Wax Seal
Sealant
™
Advertisement
