5
Negative sign ((-)), base-n symbols (d, h, b, o)
Metric conversion commands (cm in, etc.), STAT Mode
6
estimated values (x ˆ , y ˆ , x ˆ
7
Multiplication where the multiplication sign is omitted
Permutation (nPr), combination (nCr), complex number polar
8
coordinate symbol (∠)
9
Dot product (•)
10
Multiplication (×), division (÷), remainder calculations (÷R)
11
Addition (+), subtraction (-)
12
and (logical operator)
13
or, xor, xnor (logical operators)
Note
• When squaring a negative value (such as -2), the value being squared must be
enclosed in parentheses (
the negative sign, inputting
appending a negative sign to the result.
• Always keep the priority sequence in mind, and enclose negative values in
parentheses when required.
Calculation Ranges, Number of
Digits, and Precision
The calculation range, number of digits used for internal calculation, and
calculation precision depends on the type of calculation you are
performing.
Calculation Range and Precision
Calculation Range
Number of Digits for
Internal Calculation
, x ˆ
)
1
2
2
). Since x
2
would result in the squaring of 2 and then
-99
±1 × 10
to ±9,999999999 × 10
15 digits
88
2
has a higher priority than
99
or 0