Wet Vacuum Cleaning; Maintenance - LG VP07 WNV Series Owner's Manual

5. WET VACUUM CLEANING

5.1. Ensur e the machine is unplugged
from the power supply. Make sure
the tank is clean and free from dust
and dirt.
5.2. Remove the dust bag and re-usable
filter; ensure the foam filter is clean
and dry. Place the foam filter over
the basket filter and adjust carefully.
5.3. Fit the required accessories or tubes
to the suction hose.
5.4. Ensure the switch is 'Off' (position
'I') before plugging into the power
supply.
5.5. Turn the switch to 'On' (position:
.)
5.6. After use, empty the tank and dry.
To vacuum large quantities of liquid, from
a sink or tank etc., do not immerse the
nozzle completely in the liquid; leave a
gap at the top of the nozzle opening
to allow an air inflow. The machine is
fitted with a float valve which blocks the
suction action when the tank has reached
its maximum capacity. The user will
notice an increase in motor noise. When
this happens, turn off the machine,
disconnect from power supply, remove
the head from the tank and empty the
liquid into a suitable receptacle or drain.
To continue vacuuming, refit the head
and proceed. After wet vacuuming, turn
the machine off and remove plug from
power supply. Empty the tank and clean/
dry the inside and outside before storage.
Remember! After wet vacuuming
the foam filter must be removed and
the re-usable filter or the dust bag
must be fitted before dry vacuuming
again.

6. MAINTENANCE

6.1. Ensure the machine is unplugged
from the power supply.
6.2. Disconnect the hose from the tank.
6.3. Undo the clasps and remove the
motor head from the tank.
6.4. Clear out any dirt or debris from the
tank and hose.
6.5. Clean the foam filter by washing it
8