Panasonic DMP-BD55K Operating Instructions Manual page 33

To select these options, perform steps 1–4 (
"Network"
IP Address/DNS Settings (
≥Press [OK] to show the following settings.
Connection Test
IP Address Auto Configuration (DHCP)
IP Address
Subnet Mask
Default Gateway
DNS Auto Configuration (DHCP)
Primary DNS
Secondary DNS
Auto Detect Connection Speed
Connection Speed Setting
This is enabled only when "Auto Detect Connection Speed" is
turned "Off".
Proxy Server Settings (
≥Press [OK] to show the following settings.
Reset to factory preset
Proxy Address
Proxy Port Number
"Others"
Off Timer
Select how long the unit remains on when it is not being
used.
Remote Control Code
Easy Setting
You can execute basic settings ("On-screen Language", "TV
Aspect", "Analog Audio Output" [BD55]).
Restore Default Settings
This returns all values in the Setup menu and the on-screen
menu, except for "Remote Control Code", "On-screen
Language", "IP Address/DNS Settings", "Proxy Server
Settings", "DVD-Video Ratings" and "BD-Video Ratings" to
the default settings.
DivX Registration [DivX] (
You need this registration code to purchase and play DivX Video-on-Demand (VOD) content.
Firmware Update ( 14)
≥Press [OK] to show the following settings.
Automatic Update Check
When this equipment remains connected to the Internet,
it will check for the latest firmware version when it is
turned on and you can update it if necessary.
Update Now
When other Panasonic products respond to this remote control
Change the remote control code on the main unit and the remote control (the two must match) if you place other Panasonic products close together.
1 Press [SETUP].
2 Press [3, 4] to select "Others" and press [OK].
3 Press [3, 4] to select "Remote Control
Code" and press [OK].
4 Press [3, 4] to select the code (1, 2, or 3) and
press [OK].
5
To change the code on the remote control
While pressing [OK], press and hold the
numbered button ([1], [2] or [3]) for more than 5 seconds.
6 Press [OK].
17)
18)
≥2 Hours
≥Set Code 1
≥Yes
≥Yes
24)
≥On
You can update the firmware manually.
30)
— — — —
≥On ≥Off
— — —. — — —. — — —. — — —
— — —. — — —. — — —. — — —
— — —. — — —. — — —. — — —
≥On ≥Off
— — —. — — —. — — —. — — —
— — —. — — —. — — —. — — —
≥On ≥Off
≥10BASE Half Duplex
≥100BASE Half Duplex
≥Yes ≥No
(The initial setting is blank.)
(The initial setting is "0".)
≥6 Hours ≥Off
≥Set Code 2 ≥Set Code 3
≥No
≥No
≥Off
Remote Control Code
Set Code 1
Set Code 2
Set Code 3
Press [  ] and [OK] together
for more than 5 seconds on
the remote.
≥10BASE Full Duplex
≥100BASE Full Duplex
When the following indicator
appears on the unit's display and
you are unable to operate the unit
The unit's remote control code
Press and hold [OK] and the
indicated number button at the
same time for more than 5 seconds.
33
RQT9243 or RQT9350