Panasonic DMP-BD55K Operating Instructions Manual page 18

Network settings
Setting the connection speed
When the connection test results in "Fail" after the IP and DNS-IP
addresses are assigned, perform the following settings.
After performing steps 1–3 (
4 Press [3, 4] to select "Auto Detect
Connection Speed" and press
[2, 1] to select "Off".
5 Press [3, 4] to select "Connection
Speed Setting" and press [2, 1] to
select a connection speed.
≥Select a connection speed in accordance with the environment of
the network connected.
≥When the settings are changed, the network connection may be
disabled depending on the device.
Setting the proxy server
In most cases, default settings can normally be used without making
any changes.
Please use this setting when instructed to by your Internet service
provider.
1 Press [SETUP].
2 Press [3, 4] to select "Network"
and press [OK].
3 Press [3, 4] to select "Proxy
Server Settings" and press [OK].
4 Press [3, 4] to select "Proxy
Address" and press [OK].
Proxy Server Settings
Reset to factory preset
Proxy Address
Proxy Port Number
OK
RETURN
18
RQT9243 or RQT9350
17)
0
5 Press [3, 4, 2, 1] to select a
character and press [OK].
Text field: shows the text you have entered
Proxy Address
_
1 1 2 3 4 5 6 7 8 9 0
2 a b c
A B C
d e f
3 D E F
4 G H I g h i
Delete 5
J K L
m n o [
6 M N O
Finish
P Q R S p q r s
7
8 T U V
9 w x y z
W X Y Z
0
. , ? !
Space
OK
0 -- 9
RETURN
Using the numbered buttons to enter characters
e.g., entering the letter "F"
1) Press [3] to move to the 3rd row.
2) Press [3] twice to highlight "F".
3) Press [OK].
Repeat this step to enter other characters.
≥Press [;] to delete.
6 Press [∫] when you complete the
entry.
7 Press [3, 4] to select "Proxy Port
Number" and press [OK].
8 Enter numbers with the numbered
buttons and press [OK].
Proxy Port Number
Please input Proxy Server Port Number and
press [OK]. Press [CANCEL] to delete the
selected character. The number will be set to
"0" if all characters are deleted and [OK] is
pressed.
0
0 - 9 Num ber
9 Press [2, 1] to select "Yes" and
press [OK].
≥The specified ports may be blocked and not be able to be used
depending on the network environment.
In order to restore the default settings
After performing steps 1–3
1) Press [3, 4] to select "Reset to factory preset" and press [OK].
2) Press [2, 1] to select "Yes" and press [OK].
+ - *
/ = %
# $ &
j k l < > @
] _
( )
~
t u v
{ }
\ I
` ^
" ' : ;