Panasonic PT-53TWD64 Operating Instructions Manual page 11

HDMI (High Definition Multimedia Interface)
input connection
About HDMI
HDMI is the first all digital consumer electronics A/V
interface that supports several uncompressed standard,
enhanced and high definition video format as well as
existing multi-channel audio format. One jack supports both
video and audio information. The HDMI/HDCP
be connected to an EIA/CEA 861
electronic device, such as a set top box or DVD player
equipped with a HDMI or DVI output connection. By
inputting a High-bandwidth Digital Content Protection
(HDCP) high definition picture source to the HDMI terminal
of this PTV, high definition pictures can be displayed on the
screen in their digital form. The HDMI input terminal is not
intended to be used with personal computers. This PTV is
compatible with 1080i, 480p and 480i formats. Select the
output of the connecting to device to match that of the PTV.
Notes:
1. HDMI/HDCP = High Definition Multimedia Interface /
High-Bandwidth Digital Copy Protection.
2. EIA/CEA-861 Profiles compliance covers profiles for
transmission of uncompressed digital video including
high bandwidth digital content protection.
Compatible formats
This PTV is compatible with following formats. Please set
the connecting device to following format.
Video signal
Format No of dots
1080i 1920 x 1080i
720 x 480p
540p (480p)
640 x 480p
540p (480i) 720 x 480i
Audio signal
When digital audio is included in the HDMI connection,
the compatible sampling frequencies are 48 KHz /
44.1Khz / 32 Khz.
1
input can
2
compliant consumer
Vertical scanning
frequency (Hz)
59.94 / 60
59.94 / 60
59.94 / 60
59.94 / 60
O
PTIONAL
Connection diagram
Follow the diagram below to connect the PTV to a set top box or a
DVD player.
ANT A
Cable In
Incoming
Cable
ANT B
TM
CableCARD
HDMI
INTERFACE
AV IN
SERVICE
ONLY
L
AUDIO IN
R CABLES NOT INCLUDED
DIGITAL AUDIO OUT
* The connector on the PTV is HDMI Type A connector.
Connecting devices with DVI out
EXTERNAL DIGITAL COMPONENT
DVI OUT L- AUDIO OUT - R
Procedure
• Connect the HDMI output from the set top box or a DVD
player to the HDMI input on the back of the PTV.
• Press TV/VIDEO button on the remote control to select
HDMI input. The connector on the PTV is HDMI Type A
connector.
• If the external device has DVI output only, use a DVI to
HDMI adaptor cable*
the PTV. Also, connect the Audio Out signal from the
external device (set top box or DVD player) to the Audio
4
In* jacks below the HDMI input.
• If you cannot display the picture because of your Digital
Set Top Box does not have a Digital Out terminal setting,
use the Component Video Input (or the S-Video Input or
Video Input). In this case, the picture will be displayed as
an analog signal.
Notes:
*3. HDMI-DVI conversion cable (TY-SCH03DH) available
on Panasonic Website: www.panasonic.com.
*4. Please refer to page 23 for Audio setting detail.
E C
QUIPMENT ONNECTIONS
TERMINALS ON BACK OF PROJECTION TELEVISION
VIDEO
Y
P
B S-VIDEO
P VIDEO
R
L
L
R
R
2
1
AUDIO COMPONENT INPUT INPUT INPUT PROG
TO AUDIO
VIDEO INPUT 1 2 3 OUT AMP
HDMI
OUT
EXTERNAL DIGITAL
COMPONENT
HDMI
AV IN
L
AUDIO IN
R
DVI to HDMI adaptor cable
3
to connect to the HDMI jack on
9