Advertisement
Cleaning & Care (cont.)
Top
Bottom
NOTE:
Although the HEPA-type filter is washable. It should be replaced every
3 to 6 months, depending on usage to ensure peak performance of
your vacuum.
WARNING:
DO NOT use the vacuum without the HEPA-type filter in place.
2. Clean the dust filter periodically with a soft brush.
3. Wipe the exterior of the vacuum with a damp cloth.
4. DO NOT immerse any electrical appliance, cord or plug into water.
5. Press the handle release button and fold down the handle for storage.
8
CLOSED
OPEN
wards.com
Troubleshooting
PROBLEM
POSSIBLE CAUSE
Vacuum won't run
1. Not firmly plugged in
2. Unit is off
3. No power in wall plug
.
Vacuum does not pick up
1. Hose is blocked
debris
2. Dust bin is full
3. Debris may be too
large
Suction is not strong
1. Hose is blocked
2. Dust bin is full
3. Filter may be dirty
MOTOR THERMOSTAT
This vacuum is equipped with a motor protective thermostat. If it should over-
heat, the thermostat will automatically turn the power off. Should this occur:
• Push the OFF/ON switch to OFF.
• Disconnect the plug from the outlet.
• Check the source of overheating problem (i.e. clogged hose or filter).
• If clogged hose or filter is found, unclog and clean.
• Wait at least 45 minutes before attempting to restart the vacuum.
1
•
POSSIBLE SOLUTION
1. Plug in firmly
2. Turn control dial to
MAN or AUTO position
3. Check fuse or circuit
breaker
1. Clear debris
2. Empty dust bin
3. Clear large debris by
hand
1. Clear debris
2. Empty dust bin
3. Clean filter
888
557
3848
•
•
9
Advertisement
