Replacement Of The Lamp - Prilux Viessa Quick Start Manual

Viessa
SENSOR
Ø330 62
20W
IP44
230V ac
WARNING
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
1/4
enero 2020
PRECAUTIONS
• Disconnect the power before handling the product.
• This product must be installed by qualified personnel, in case of
• Keep it away from children.
• Do not immerse this product in water or handle it with wet hands.
Ø380 68
• For storage, store the product in a dry place and protected from
30W
• If the luminaire is cracked or damaged, replace it with a new
MOUNTING
1. Turn off the power supply.
2. Take the back of the device and measure the distance between
3. Mark on the surface where you want to install the luminaire the
4. Drill the holes in the surface and place a block in each hole (Fig.
5. Put the back of the appliance and fix it with the screws (Fig. 2).
6. Connect the luminaire to the power supply, inserting a direct
7. Once connected, proceed to place the luminaire in the support
8. Restore power supply.

REPLACEMENT OF THE LAMP:

• Lamp not replaceable.
NOTICE:
DO NOT INSTALL THE LUMINAIRES WITH AN INTERDISTANCE LESS THAN
2m TO DO SO TO CAUSE INTERFERENCE IN THEMSELVES
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
doubt consult a specialized technician.
bumps and moisture.
one.
the holes.
position of the holes, help with a level so that the holes are in the
correct position.
1).
power cable from the luminaire to the power supply (Fig. 3).
and fix it, turning the tabs.