Connections - Panasonic TH-42PWD6UX Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
AC cord connection (see page 12)
SPEAKERS
Terminals (R)
– AC cord fixing
1. Open the clamper.
– Cable fixing bands
Secure any excess cables with bands as required.
Pass the attached
cable fixing band
through the clip as
shown in the figure.
1
Optional Terminal Board insert Slots (covered)
SLOT1
2. Insert the AC cord and
close the clamper
securely.
AC cord
Clamper
Note: The power plug in the illustration may not be the type fitted to your set.
To secure cables connected to Terminals, wrap the cable fixing band
around them then pass the pointed end through the locking block, as
shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the
supplied fixing band.
2
SLOT3
SLOT2
From EXTERNAL monitor terminal
on Computer (see page 10)
1
2
SPEAKERS
Terminals (L)
2
3. Slide up the clamper and fix
the AC cord plug securely.
To tighten:
Pull
PC IN
1
When loosen
the clamper:
To loosen:
Push the
catch
Pull
AUDIO
SERIAL
From SERIAL Terminal on
Computer (see page 11)
9