SILISYSTEM CLONE 433 AU 2T Instructions For Use And Set Up
  1. Manuals
  2. Brands
  3. SILISYSTEM Manuals
  4. Remote Control
  5. CLONE 433 AU 2T
  6. Instructions for use and set up

SILISYSTEM CLONE 433 AU 2T Instructions For Use And Set Up

Programmable remote control
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

CLONE 433 AU 2T
PROGRAMMABLE REMOTE CONTROL
INSTRUCTIONS FOR
USE AND SET UP
REV. 25-10-2016
PLEASE READ ENTIRELY THESE
INSTRUCTIONS FOR THE PROPER USE
OF THE PRODUCT!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLONE 433 AU 2T and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for SILISYSTEM CLONE 433 AU 2T

Summary of Contents for SILISYSTEM CLONE 433 AU 2T

  • Page 1 CLONE 433 AU 2T PROGRAMMABLE REMOTE CONTROL INSTRUCTIONS FOR USE AND SET UP REV. 25-10-2016 PLEASE READ ENTIRELY THESE INSTRUCTIONS FOR THE PROPER USE OF THE PRODUCT!
  • Page 2 WHEN TO USE IT? The radio control CLONE 433 AU 2T can duplicate any type of remote control with permanent code, with transmission frequency of 433.92 MHz HOW TO PROGRAM IT? 1 - SET UP Red Led will firstly turns on steady...
  • Page 3 CLONE 433 AU 2T PROGRAMMABLE REMOTE CONTROL HOW TO SET UP THE FREQUENCY? This model NOT NEED any calibration. HOW TO REPLACE THE BATTERY? By using a screwdriver, put it in the hole of the key ring and by leveraging on the edge of the radio control, remove the metal stop, after that raise the cover, remove the dead battery and insert the new one paying attention to the correct polarity.
  • Page 4 EN 301 489-1 Electromagnetic Compatibility (EMC) EN60950 Safety The device CLONE 433 AU 2T has been proved in a typical configuration of installation and complies with the essential requirements and the other relevant provisions laid down by Directive: 1999/5/CE (R&TTE Directive)

Table of Contents