SILISYSTEM CLONE RC2 4T Instructions For Use

16models rolling code duplicator

Advertisement

CLONE Rc2 4T
16 MODELS ROLLING CODE DUPLICATOR
INSTRUCTIONS
FOR USE AND SET UP
REV. 25-10-2016
PLEASE READ ENTIRELY THESE
INSTRUCTIONS FOR THE PROPER USE
OF THE PRODUCT!

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLONE RC2 4T and is the answer not in the manual?

Questions and answers

Summary of Contents for SILISYSTEM CLONE RC2 4T

  • Page 1 CLONE Rc2 4T 16 MODELS ROLLING CODE DUPLICATOR INSTRUCTIONS FOR USE AND SET UP REV. 25-10-2016 PLEASE READ ENTIRELY THESE INSTRUCTIONS FOR THE PROPER USE OF THE PRODUCT!
  • Page 2 WHEN TO USE IT? The CLONE RC2 4T allows to create a new radio control of the following brands with 433.92 MHz transmission frequency. To each button can be assigned a type, also different types that are in the list.
  • Page 3 HOW TO REPLACE THE BATTERY? By using a phillips head screwdriver, unscrew the screw at the back of the CLONE RC2 4T remote control. The remote control is powered by a 3V LITHIUM BATTERY with initials CR2032 Remove a dead battery and insert the new one paying attention to the correct polarity.
  • Page 4 EN60950 Safety With the current “SILISYSTEM TECHNOLOGY srl” declares that: The device “CLONE RC2 4T” has been proved in a typical configuration of installation and complies with the essential requirements and the other relevant provisions laid down by Directive: 1999/5/CE (R&TTE Directive)

Table of Contents