Table of Contents
Advertisement
Setting Up
F F F F
Match (U U U U ) on the front of the Fus-
er Oil Unit and the arrow on the
Fusing Unit as shown in the illus-
tration.
2
Important
❒ Be careful not to get oil on the
metal part of the left side of the
Fuser Oil Unit.
G G G G
Insert the left and right protru-
sions of the Fuser Oil Unit into
the white holders of the Fusing
Unit (A A A A ), and then move the Fus-
er Oil Unit in the direction shown
by the arrow (B B B B ) to attach the Fus-
er Oil Unit to the Fusing Unit.
16
H H H H
Holding the green handle with
one hand, use your other hand to
push the front area of the handle
to a slight slant, and then push the
Fusing Unit slowly to the back.
ZDJH055J
Confirm that the Fusing Unit is set
to the printer vertically.
Note
❒ Confirm that the Fuser Oil Unit
is facing the inside of the print-
er.
Important
❒ Confirm that the Fusing Unit is
in appropriate position.
I I I I
Close the upper left cover (A A A A ) and
push the handle (B B B B ) slowly to the
back until it clicks.
ZDJH054J
ZDJH050E
ZDJH051J
Advertisement
Table of Contents
