Table of Contents
Advertisement
Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
7 Removal and installation / 7.2 Removing the turbocharger
© Copyright 2020 . All rights reserved.
Ribs (01) not in the middle at the top:
w
Completely remove the bearing casing insulation (02) and place a
u
sling around the bearing casing.
Attach one lifting gear each to the two ribs of the bearing casing
u
provided for this purpose.
Loosen the fixing screws at the foot.
u
Lift the turbocharger off the engine and set it down to one side.
u
WARNING
If support for the turbocharger is missing or defective, the turbochar-
ger can tip over during installation and removal and cause serious injur-
ies or even fatal accidents.
Support the turbocharger at a suitable point.
u
Cover the oil connection.
u
HZTL2481_EN
Rev.D
March 2020
Advertisement
Table of Contents
