Architectural Mailboxes 2572 Mounting Instructions

IMPORTANT! This
mailbox is intended to be
mounted under an eave or
another protected area.
1
Using the guide on the back of these instructions,
mark the wall at the center of each crosshair. Use a
level to ensure a straight installation (optional).
2
Drill into the wall at each marked location. Use a
1/4" drill bit for brick or other masonry wall. Use a
1/16" drill bit for wood wall.
1/4" masonry bit
- or -
1/16" wood bit
x4
Questions, Comments, Concerns?
www.architecturalmailboxes.com
support@architecturalmailboxes.com
Wall Mount Mailbox | Model 2572
MOUNTING INSTRUCTIONS
R
Hardware
(included)
x 4, screws
x 4, plastic
anchors
Need keys? Visit us at...
www.architecturalmailboxes.com/keys
Tools
(not included)
One Drill
3
Skip this step if installing into wood.
Insert the included plastic anchors into the drilled
holes. Gently tap them in if necessary.
x4
Insert the screws into the bottom two drilled holes
4
and secure with a screwdriver. Hang the mailbox
onto the secured screws using the bottom eyelet
holes on the back of the mailbox.
5
While the mailbox is hanging on the bottom screws,
insert the remaining two screws into the top holes
and secure with a screwdriver.
One Phillips Screwdriver
One Drill Bit
1/4" masonry bit or 1/16"
wood bit
Find us on social media!
@archmailboxes
Rev. E © 2020, Architectural Mailboxes, LLC