Advertisement
Installation
The battery is connected to Performance Box Touch using the Richter mounting system on the rear of the unit. Insert the
prongs from the back of the battery in to the rear of Performance Box Touch and then push upwards to secure.
Richter mounting system on back of Performance
Box Touch
Charging
The battery can be charged whilst installed within Performance Box Touch if the unit is being
source, or can be charged when removed from the unit using the USB port located above the Power button and the
supplied USB cable (USB2-007241).
The battery will take approximately 3.5 hours to charge. For fastest charge, it is recommended to charge the
battery from a mains power source when disconnected from Performance Box Touch.
If you are having issues charging the battery, please take a look at our
Auto Power Off
When the unit is determined to be 'idle' (tracking zero satellites, is not logging and has had no screen interactions for 5
consecutive minutes), Performance Box Touch will power off to preserve battery.
Before powering off, a warning screen will appear, allowing you to press the screen to cancel the auto power off within
10 seconds.
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Knowledge_Base/
Richter mounting system on rear of battery
(RLACS290)
troubleshooting
page.
powered via a power
Performance_Box_Touch_Battery
2
Advertisement
