Accessories; Checking Accessories - Fujitsu Plasmavision PDS4211 User Manual

ACCESSORIES

CHECKING ACCESSORIES

One connector cover
Four safety brackets
(types A x 2, type B x 2) (screw A x 2, screw B x 2)
HOW TO USE ACCESSORIES
Cable clampers
Use the supplied cable clampers to bind the display's signal or power cables. Use them as shown in the figure when mounting the display
on the wall, using the wall-mounting unit, or hanging it from the ceiling using the hanging unit.
When you run signal cables
downwards
Connector cover
When you finish binding the cables using the cable clampers, you need to attach the
connector cover to the display.
To do this, use nippers to cut out a section of the connector cover such that the cables can
be pulled out through that section. Then attach the cover to the display.
When attaching the connector cover, make sure that the upper and lower projections on
the cover fit properly into the corresponding sections on the display.
Information
Cables for connecting the display to external equipment are not supplied. Contact your dealer for more information on these products.
One remote control
(for remote control)
Four screws
two small ferrite cores
(with wire clampers)
Screw A
(10 mm)
Screw B
(20 mm)
One strap Two AA batteries
Three large and Two cable clampers
When you run signal cables to the right
One user's manual
Manual
Three power cables
Projections (to be fit into corresponding
sections on the display)
E-5