Table of Contents
Related Manuals for Dewenwils HRLS21B
Summary of Contents for Dewenwils HRLS21B
- Page 1 Remote Control Light Socket [Instruction Manual] Thank you for your purchase. Please contact us if you have any questions. We will get back to you within 24 hours. Please attach your Order ID so that we can serve you better. V210818...
- Page 2 Warning: To reduce the risk of fire, electric shock, or personal injury, please strictly follow the instructions. 1. Indoor use only. Avoid high humidity, high temperature, and areas with a high magnetic field. 2. Always be sure to cut off the power before installing the receiver. 3.
- Page 3 Operating Instructions 1. Remove the isolation tab in the battery compartment of the transmitter. 2. Press the ON/OFF button on the wall switch remote control to turn the receiver on and off. Canceling Programming To remove a receiver from all transmitter parings (no remote transmitter can control it): 1.
- Page 4 2. Release the program button and then press it again. The indicator light will be off. All the programming has been canceled. Programming the Receiver The receivers and transmitters have been pre-paired for immediately use, but there are few units may not be pre-programmed or programmed incorrectly, or you want to customize the configuration to meet your needs.
- Page 5 1. Press the program button on the receiver for 3 seconds until the indicator light starts to flash slowly. 2. Release the program button and then press the “on” or “off ”button on the remote control. 3. Programming / paring is successful when the indicator light stops blinking. Note: Each set of ON or OFF button can be paired with and control several outlets;...
- Page 6 Mounting the Wall Switch Shown as the figure Battery Replacement 1. If you find the receiver is working abnormally or the indicator on the transmitter becomes dim, replace the remote battery with a new DC 12V (type 23A) battery, making sure the polarity +/- of the battery is correct. 2.
- Page 7 Troubleshooting In the case that one receiver is unresponsive to the remote control, please follow the steps below to resolve the issue: 1. If the wire switch receiver is unresponsive to the remote control, please refer to the "Canceling Programming" and "Programming the Receiver" sections in the manual to reprogram the receiver.
- Page 8 One Year Limited Warranty DEWENWILS warrants this product to be free from defects in material and workmanship for a period of one year from the date of purchase. Warranty is void if damage is caused by misuse or improper installation.
Need help?
Do you have a question about the HRLS21B and is the answer not in the manual?
Questions and answers