TAPO-FIX CB 75 N Manual

Manual
tapo-fix CB 75 N
Working Width 82 cm
tapo-fix CB 1000 N
Working Width 106 cm
1. Set up the Pasting Machine
Locking
1a. Release the locking on the
frame. Unfold the right leg.
Accessories (not included): CB Counter, Sliding cutter 75-800, Table-Widening,
Equipment Table 70 F
2. Align
Put the Pasting Machine CB 75 N or CB 1000 N in front of the
Equipment Table. Align and determine the castors. Mount the Table-
Widening at the Equipment Table 70 F. If working with Equipment Table
75 N or 1000 N align and determine the castors.
When available, mount the Sliding cutter and the CB Counter.
4. Adjust paste thickness
Adjust the thickness of the paste with the adjustment knobs on both sides.
Set 1 for thin wallpapers, accordingly more paste for thicker
wallpapers. After adjusting the thickness tigthen the fixing screw in the
knob.
Important: Do not expose the paste roll to direct sunlight or heat.
Clean only with cold water.
1b. Slide the slipshell across the
hinge.
fixing screw
knob
1c. Unfold the left leg.
Accessories (not included): CB Counter, Sliding cutter 75-800
3. Fill in paste
Mix paste according to the manufacturer's instructions.
(If possible, use special paste for Pasting Machines)
Fill the paste tray up to 2cm below the edge.
Accessories (not included): CB Counter, Sliding cutter 75-800
5. Fit in the wallpaper
Slide the wallpaper rod though the roll and fix it in the middle with the
stop discs, then hang it in the holder.
1d. Slide the slipshell across the
hinge and raise up the machine.