Fujitsu Lifebook T5010 User Manual page 109

Problem
The built-in display is blank
when you turn on your
LifeBook Tablet PC.
(continued)
The Tablet PC turned on
with a series of beeps and
the built-in display is blank.
The display goes blank by
itself after you have been
using it.
Your display won't turn on
when the system is turned
on or when it has
resumed.
The display does not
close.
The display has bright or
dark spots.
Possible Cause
Power management timeouts
are set for short intervals and
you didn't see the display go
on and off again.
Power On Self Test (POST)
has detected a failure which
does not allow the display to
operate.
The Tablet PC has gone into
Video timeout, Sleep mode,
or Save-to-Disk mode
because you have not used it
for a period of time.
The power management time-
outs may be set for very short
intervals and you failed to
notice the display come on
and go off again.
The system may be pass-
word-protected.
A foreign object, such as a
paper clip, is stuck between
the display and keyboard.
If the spots are very tiny and
few in number, this is normal
for a large LCD display.
109 - Troubleshooting
Possible Solutions
Press a keyboard button or move the mouse to restore oper-
ation. If that fails, push the Power/Suspend/Resume button.
(The display may be shut off by Sleep mode, Auto Suspend
or Video Timeout)
Contact your support representative.
Press any button on the keyboard, or move the mouse to
restore operation. If that fails, push the Power/Sus-
pend/Resume button. Check your power management set-
tings, or close your applications and go to the Power Savings
menu of the setup utility to adjust the timeout values to better
suit your operation needs. See "BIOS Setup Utility" on
page 70.
Press any button on the keyboard, or move the mouse to
restore operation. If that fails, push the Power/Sus-
pend/Resume button. (The display may be shut off by Sleep
Mode, Auto Suspend or Video Timeout)
Check the status indicator panel to verify that the Security
icon is blinking. If it is blinking, enter your password.
Remove all foreign objects from the keyboard.
This is normal; do nothing.