Fujitsu Lifebook T3010 Bios Manual page 7

Menu Field Options
■
Heads: A number between
1 and 16
■
Sectors: A number between
0 and 63
■
Maximum Display only
Capacity:
■
Multi-Sector Disabled
Transfers:
■
2 Sectors
■
4 Sectors
■
8 Sectors
■
16 Sectors
■
LBA Mode Control: Disabled
■
Enabled
■
Transfer Mode: Standard
■
Fast PIO 1
■
Fast PIO 2
■
Fast PIO 3
■
Fast PIO 4
■
Multiword DMA 1
■
Multiword DMA 2
■
Ultra DMA Mode: Disabled
■
Mode 0
■
Mode 1
■
Mode 2
■
Mode 3
■
Mode 4
■
Mode 5
C A U T I O N
■ A bootable CD-ROM may have either a floppy disk or hard drive format. When the bootable CD-ROM is used, the
drive allocations change automatically without changing the BIOS setup. If a floppy disk format CD-ROM is used, the
CD-ROM becomes Drive A. The CD-ROM will only take drive C: (hard drive format) if the internal hard drive is not
present or is disabled. The bootable CD-ROM can never use a C: designation if a formatted internal hard drive is
present since the C: designator is always reserved for the internal hard drive.The boot sequence ignores the new drive
designations, however, your application software will use the new designations.
Be careful of the operating environment when booting from a CD-ROM or you may overwrite files by mistake.
■
Exiting from Main Menu
When you have finished setting the parameters on this menu, you can either exit from the setup utility, or move to
another menu. If you wish to exit from the setup utility, press the [Esc] key or use the cursor keys to go to the Exit
menu or to move to another menu.
Default Description
–— This item is active only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
–— This item is active only when Hard Disk is selected as type. You can
change the value by incrementing (pressing the [Spacebar]) or by
typing in the number.
–— Displays the maximum capacity of the drive calculated from the
parameters of the hard disk when Auto is selected and the type
is identified as hard disk.
[16 Sectors] This option cannot be changed when Auto is selected. Specify the
number of sectors per block for multiple sector transfer.
[Enabled] Enables or disables logical Block Addressing in place of Cylinder,
Head, Sector addressing. This option cannot be changed when Auto
is selected.
[Multiword Selects the method for moving data to/from the drive. Autotype the
DMA 2] drive to select the optimum transfer mode. This option cannot be
changed when Auto is selected.
[Disabled] Selects the method for moving data to/from the drive. Autotype the
drive to select the optimum transfer mode. This option cannot be
changed when Auto is selected.
7
M a i n M e n u