Table of Contents
Advertisement
L i f e B o o k S S e r i e s N o t e b o o k B I O S
EXIT MENU – LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow the instructions for Navigating Through the Setup Utility to
make any changes. (See Navigating Through the Setup Utility on page 2 for more information). The following table
shows the names of the menu fields for the Exit menu, the default settings and a description of the field's function and
any special information needed to help understand the field's use.
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
F1
Help
ESC
Exit
Table 19: Fields, Options and Defaults for the Exit Menu
Menu Field
Description
Exit Saving
Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS memory and
then exit the setup utility. A confirmation message Save Configuration changes and exit now? [Yes]
Changes
[No] will be displayed.
Exit Discarding
Selecting Exit Discarding Changes and Exit will exit the setup utility with out writing to the BIOS memory. When the
Changes
BIOS recognizes this selection it will load the operating system and begin operation.
Load Setup
Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then display the message
Load default configuration now? [Yes] [No]. When confirmed the setup utility will return to the Exit
Defaults
Menu. To return to another menu follow the directions in the Navigating Through the Setup Utility Section.
Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The message Load
Discard Changes
previous now? [Yes] [No] will be displayed. When confirmed the utility will return to the Exit menu. To
return to another menu, follow the directions in the Navigating Through the Setup Utility Section.
Selecting Save Changes causes the new settings in all menus to be written to the BIOS memory. The message Save
Save Changes
configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup utility will return
to the Exit menu. To go to another menu, follow the directions in the Navigating Through the Setup Utility section.
PhoenixBIOS Setup Utility
Main
Advanced
Security
Select Item
-/Space
Select Menu
Enter
Figure 19. Exit Menu
Boot
Exit
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
Change Values
F9
Select
Sub-Menu
F10
28
Setup Defaults
Save and Exit
Advertisement
Table of Contents
