Bosch WAN24109GB User Manual And Installation Instructiions page 51

Fault
The spin programme
does not start.
Rushing, hissing
noise.
Loud noises during
the spin cycle.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
Creasing.
Cause and troubleshooting
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Spin programme.
▶
Water is flushed under pressure into the detergent
drawer.
Not a fault – normal operating noise.
▶
Appliance is not correctly aligned.
Aligning the appliance
▶
The appliance feet are not fixed.
Secure the appliance feet. Aligning the appliance
▶
Transit bolts have not been removed.
Removing the transit bolts
▶
Foreign bodies have got into the drain pump.
→ "Cleaning the drain pump", Page 41
▶
The drain pump is active, the detergent solution is
pumped out.
Not a fault – normal operating noise.
▶
The spin speed is too high.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is too large.
The next time you run a wash cycle, reduce the
▶
amount of laundry being loaded.
The wrong programme is selected for the type of fab-
ric.
Select the programmes that are suitable for the
▶
type of fabric.
→ "Programmes", Page 23
Troubleshooting en
51