Thank you for purchasing this product. For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. Table of Contents 1. Introduction..............................3 2. Package Contents............................3 3. Features................................4 4.
1. Introduction The HDMI Extender over Single Cat5e/6 with IR extends high definition video and audio signals and IR, at a distance of up to 164ft/50m over a single Cat5e/6 cable. Features EDID management, which allows and encourages source and display “handshake” for seamless integration.
3. Features Allows HDMI Audio/Video and IR signals to be transmitted over a single Cat5e/6 cable. Supports copying EDID from receiver display or loop out display. Allows for cascading via additional HDMI loop out port. Supports Power over cable function. ...
Power consumption:1.5 watts (TX); 1.0 watts (RX) Operation temperature: 32~104 °F Storage temperature: -4 ~140 °F Relative humidity: 20~90 % RH (no condensation) 5. Panel Descriptions 5.1 Transmitting Unit HDMI in: This slot is where you connect the HDMI output port of your source equipment such as DVD/Blu-ray players or Set-Top-Box with an HDMI cable.
5.2 Receiver Unit EQ switcher: HDMI Receiver equalizer switcher. HDMI out: This slot is to connect the HDMI input port of your display such as an HDTV. IR in: Connect to the IR Receiver for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR receiver.
5.3 RX Equalizer Distance Adjust If you see flickering or blinking image on the display, adjust the EQ switch to improve the cable skew. MAX stands for the strongest HDMI signal level for the longest possible transmission length while MIN stands for the weakest HDMI signal level for short transmission length.
7. Connect and Operate 1. Connect a source (such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver) to the HDMI input on the Transmitting unit. 2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
8. Wideband IR (30KHz---60KHz) Introduction IR BLASTER (TX) To control the source: Plug IR Blaster into IR TX port of transmitter unit; place blaster in front of the IR eye of the source. To control the display: Plug IR Blaster into IR TX port of receiver unit; place blaster in front of the IR eye of the display.