Download
Share
Print this page
IN-COMMAND Lite Troubleshooting Manual
  1. Manuals
  2. Brands
  3. IN-COMMAND Manuals
  4. Automobile Accessories
  5. Lite
  6. Troubleshooting manual

IN-COMMAND Lite Troubleshooting Manual

Hide thumbs Also See for Lite:

Advertisement

Quick Links

Download this manual
TROUBLESHOOTING GUIDE
1

Advertisement

loading

Related Manuals for IN-COMMAND Lite

Summary of Contents for IN-COMMAND Lite

  • Page 1 TROUBLESHOOTING GUIDE...
  • Page 2 The iN-Command Lite system is comprised of two parts; the BCM (Body Control Module) and either the DC (Display Commander) or SP (Switch Plate). The iN-Command Lite system works in conjunction with the RV Switch Panel to provide remote app control for one light group and up to seven motor functions.
  • Page 3 Electric Wiring Guide for the BCM BCM Pins 1-18 are on the Left side, ascending from Top to Bottom. BCM Pins 19-36 on the Right side, ascending from Bottom to Top. BCM Pins GND, RX, TX and +12V DC (DC RX/TX wires) are at the Top Right Side. The TX (transmit) and RX (receive) connections at each device are crossed (crossover cable).
  • Page 4 Electric Wiring for the DC/SP...
  • Page 5 BCM Pin Values Name BCM Function Note Amps Motor 1 Out 12V from Switch 12V for Motor 1 Extend Reversing Polarity DC Motor 12V/GND Motor 1 In 12V from Switch 12V for Motor 1 Retract Reversing Polarity DC Motor 12V/GND Motor 2 Out 12V from Switch 12V for Motor 2 Extend...
  • Page 6 LED’s will stay lit while the SP is initializing. Once the LED’s turn off, the SP is ready for operation. When the DC is powered on, initializing will appear on the display. Once initializing is replaced by iN-Command Lite on...
  • Page 7 Pairing the Mobile App iN-Command Lite is able to pair with Android and iOS devices via the mobile app. Only one mobile device can be paired with iN-Command Lite at a time.
  • Page 8 To connect NCS50DC/SP with another device, perform the following steps: NCS50SP: Long press “Bluetooth Pairing” button for 7 ~ 10 seconds to unpair device. NCS50SP will flash blue light twice when device is unpaired. NCS50DC: In DC Menu, select unpair device and press the enter button. A message of “Are You Sure” will appear. Press “Enter” button again. App: When powering down the App, select the box to “Unpair Device”.
  • Page 9 Editing the Floor Plan...

  • Page 10: Troubleshooting

    DC/SP; TX from BCM connects to RX on DC/SP). The NCS50 BCM with the SP/DC allows you to either use the RV Switch Panel or iN-Command App to control your RV’s functions. The BCM Pin Values portion of this guide will clear most issues. Basically, if the BCM does not have the desired voltage, or signal input, it will not be able to function or read battery voltage.