Advertisement
WARNING! Before making any cut, make sure the mitre lock handle is fully tightened.
Preset Mitre Locks
There are preset mitre stops at 0˚, 15˚, 22.5˚, 30˚ and 45˚ to the left and right.
While the table is being rotated, the table will stop at the next positive stop. Once the desired
angle is obtained, use the mitre lock handle to lock the table.
Vise Assembly (Vertical)
The vertical vise (A) Fig.3 can be installed in two positions on either the left or right side
of the guide fence. Insert the vise rod (B) into the hole in the guide fence and tighten the
vise lock knob (C) to secure the vise rod.
Retractable Extension Wings
Before using this mitre saw, it is recommended to use the extension wings to support your
workpiece. Simply loosen extension wing lock knob (A) Fig.5, pull out the extension wing
(B) Fig.5 and secure it in place by tightening the extension wing lock knob (A). Repeat for
the other extension wing.
Dust Bag
The dust bag (A) Fig.5 fits into the dust bag adaptor (B) at the rear of the saw head. For more
efficient operation, empty the dust bag when it is no more than half full. This allows better air
flow through the bag.
5. Adjustments
Bench Mounting
The saw base has holes to facilitate bench mounting.
1. Fix the saw to a bench using 4 hex. bolts and hex. nuts.
2. If desired, you can mount the saw to a piece of 13mm or thicker plywood which can then be clamped to your work support or moved to
other job sites and reclamped.
CAUTION: Make sure that the mounting surface is not warped as an uneven surface can cause binding and inaccurate sawing.
Adjusting Fence Extensions
This mitre saw comes with a back fence with fence extensions (A) Fig.6 at both ends which
slide outwards for additional back support for those long workpieces. Please note that during
steep bevel cut operations, these fence extensions must be fully extended to not interfere with
the motor housing or blade guard. To adjust the position of each fence extension;
1. Loosen the fence extension cap screw (B) using supplied hex. key.
2. Loosen the fence extension rear lock knob (C).
3. Slide the fence extension outwards to the desired position and retighten the cap screw and
rear lock knob.
JEFSWMIT12-110 • JEFSWMIT12-230
305mm SLIDING COMPOUND MITRE SAW
10
USER MANUAL
V1.2
Fig.3
Fig.4
Fig.5
Fig.6
Advertisement
