Fujitsu LifeBook C-4120 Manual page 89

Problem
Shutdown and Startup Problems
The Power button does not work.
The system powers up, and displays
power on information, but fails to load
the operating system.
T r o u b l e s h o o t i n g
Possible Cause
1. The Power button is disabled from
the Advanced submenu of the Power menu
of the setup utility.
2. You did not hold the button in long enough.
3. There may be a conflict with the
application software.
1. The boot sequence settings of the setup utility
are not compatible with your configuration.
2. You have a secured system requiring a
password to load your operating system.
3. Internal hard drive was not detected.
L i f e B o o k C S e r i e s f r o m F u j i t s u
Possible Solution
1. Enable the button from the setup utility.
(See page 43.)
2. Hold the button longer. This may need to
be a very long time if your application is
preventing the CPU from checking for
button pushes.
3. Close all applications, and try the
button again.
1. Set the operating source by pressing the Esc
key while the Fujitsu logo is on screen or
use the F2 key and enter the setup utility
and adjust the source settings from the
Boot menu.
2. Make sure you have the right password.
Enter the setup utility and verify the
Security settings and modify them as appro-
priate. (See Security Menu in the BIOS guide.
See page 44 for more information.)
3. Use the BIOS setup utility Main menu,
Primary Master submenu to try to auto
detect the internal hard drive.
75