General Product Data; Unpacking And Set-Up; Unpacking - Demtech Bone-Cutter BC-100/A Operator's Manual

Table of Contents

Rev. A, January 2021

3 General Product Data

The DEMTECH Services, Inc. Bone-Cutter Test Coupon Cutter, hereinafter referred to as the Bone-

Cutter or Cutter makes for a very efficient post weld testing process. The Bone-Cutter has been

designed to withstand the wear and tear of a jobsite as well as provide the user with an easy-to-use

reliable coupon cutter. A quick release retractable base and handle make packing and unpacking quick

and easy. A lightweight durable cover helps prevent injury and a 10 sample chamber allows for

efficient high volume testing.

4.1

Before opening the shipping/storage case for the first time and unpacking the Bone-Cutter,

inspect the outside of the case thoroughly for any signs of mishandling or damage during

shipping. Report any damage to the shipping carrier immediately and do not proceed with

unpacking. You should consult your administration concerning claims for shipping damage.

Please notify DEMTECH Services, Inc. or your authorized DEMTECH distributor where the

product was purchased in the event of any shipping damage.

Unlatch and open the shipping/storage case lid and inspect inside the case and equipment

thoroughly for any signs of mishandling or damage during shipping. Report any damage to

the shipping carrier immediately and do not proceed with unpacking. You should consult

your administration concerning claims for shipping damage. Please notify DEMTECH

Services, Inc. or your authorized DEMTECH distributor where the product was purchased in

the event of any shipping damage.

The Bone-Cutter Test Coupon Cutter is delivered to you in a sturdy, reusable

shipping/storage case. The custom foam insert protects the unit from damage during

shipping and should be stored in the case at all times when not in use. When the unit is

out of the case, make sure the lid is closed to avoid dirt, dust and rain from getting inside.

Once the Bone-Cutter has been removed from the case, it is ready for use except for any

necessary set-up adjustments. For set-up procedure, refer to the set-up adjustment section in

this manual.

Make note of the orientation of the equipment and packing foam inserts inside the shipping

case to facilitate any repackaging requirements in the future. To avoid injury and/or damage

to the cutter, be sure to use adequate care when lifting, removing or replacing the welder into

the shipping/storage case. The cutter must be removed from the shipping/storage case and

placed in an appropriate location suitable for the cutting you intend to perform.

Bone-Cutter Operator's Manual

Table of Contents