Checking The Computer Recognition Of New Memory Capacity - Fujitsu Lifebook B2630 User Manual

4. Store the memory upgrade module in a static
guarded sleeve.
5. Replace the cover by following steps 9 and 10 of
Installing a Memory Upgrade Module.
P O I N T
After installing your new memory module, you must
complete the Resetting the Hibernate Parameters
procedure in order for the Hibernate mode to operate
properly on your notebook. See "Hibernate Mode" on
page 33.
CHECKING THE COMPUTER RECOGNITION
OF NEW MEMORY CAPACITY
Once you have changed the system memory capacity, be
sure to check that your notebook has recognized the
change.
You can check the memory capacity by looking at the
main menu of the BIOS setup:
1. Turn on the power to your notebook using the
power switch.
2. Allow the system to start booting and press the [F2]
key once the Fujitsu logo appears on the screen. This
will open the main menu of the BIOS setup. Go to
the Info tab to view the current settings. See "BIOS
Setup Utility" on page 29.
The System Memory and the Extended Memory
capacity, as detected by your notebook during the Power
On Self Test (POST), are displayed at the bottom of the
main menu screen.
P O I N T
If the total memory displayed is incorrect, check that
your memory upgrade module is properly installed. If
the module is properly installed and the capacity is still
not correctly recognized, see "Troubleshooting" on
page 51.
U s e r I n s t a l l a b l e F e a t u r e s
43