Table of Contents
Advertisement
Symptom
The system powers up, and displays the power on
information, but fails to load operating system.
T r o u b l e s h o o t i n g
Possible Cause
2. You did not hold the button in long enough.
3. There may be a conflict with the
application software.
1. The boot sequence settings of the setup utility
are not compatible with your configuration.
2. You have a secured system requiring a
password to load your operating system.
3. Internal hard drive was not detected.
L i f e B o o k B 1 1 2 f r o m F u j i t s u
Possible Solution
2. Hold the button longer. This may need to be
a very long time if your application is preven-
ting the CPU from checking for button pushes.
3. Close all applications, and try the
button again.
1. Set the operating source by pressing the Esc
key while the Fujitsu logo is on screen or use
the F2 key and enter the setup utility and
adjust the source settings from the Boot
menu. (See Boot Menu on page 91.)
2. Make sure you have the right password. Enter
the setup utility and verify the Security
settings and modify them as appropriate.
(See Security Menu on pages 79-82.)
3. Use the BIOS setup utility Main menu,
Primary Adapter submenu to try to auto
detect the internal hard drive.
125
Advertisement
Table of Contents
