Table of Contents
Advertisement
Air recirculation
The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter, and is conveyed back into
the kitchen.
To bind odours in air recirculation mode, you
Note:
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or from
the Online Shop.
1Operating the appliance
T hese instructions apply to several appliance variants.
O p e r a t i n g t h e a p p l i a n c e
It is possible that individual features are described
which do not apply to your appliance.
Switch on the extractor hood when you start
Note:
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel
Explanation
Light on/off
<
Fan on/off
#
-
Reduces the fan speed
+
Increases the fan speeds/intensive setting
Setting the fan
Switching on
Pull out the filter pull-out and press the
fan starts at setting 2.
Press the + or - button to change the fan strength.
Switching off
Press the
#
button. Slide the filter pull-out in.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button until all of the LEDs in the display
light up. The intensive setting is activated.
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
The run time is limited. The fan is then automatically
reduced to a lower fan setting. You can switch back
manually at any time.
Fan run-on time
If you slide in the filter pull-out, the run-on time will be
activated for as long as the extractor hood is operating.
After approx. 10 minutes, the fan switches off
automatically.
Lighting
The lighting can be switched on and off independently
of the ventilation.
Press the
2Cleaning and maintenance
C l e a n i n g a n d m a i n t e n a n c e
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
:
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
button. The
#
information in the table. Do not use any of the following:
■
■
■
■
Wash new sponge cloths thoroughly before use.
button.
A
:
Warning – Risk of burns!
Warning – Risk of electric shock!
Warning – Risk of electric shock!
Warning – Risk of injury!
Harsh or abrasive cleaning agents,
Cleaning agents with a high alcohol content,
Hard scouring pads or cleaning sponges,
High-pressure cleaners or steam cleaners.
Operating the appliance
en
5
Advertisement
Table of Contents
