Power On - Fujitsu 985Tx User Manual

Type III cards are always Card 1 only. The
PC Card Access indicator will flash if your
software tries to access a PC Card even if
none are installed.
P O I N T
Windows 95 displays of PC Card slot
numbers may be different from the
Status Indicator panel display of
slot numbers.
NumLk Indicator
The NumLk indicator tells you the internal key-
board is set in ten-key numeric mode. (See page
32 for more information on the nume ric keypad.)
You can activate the NumLk mode by pressing
the Scr Lk/NumLk key while holding down the
Shift key. Deactivate the mode the same way
you activated it.
CapsLock Indicator
The CapsLock indicator tells you when the key-
board is set for all capital letters. Activate the
U s i n g Y o u r L i f e B o o k 9 0 0 S e r i e s
capitals lock mode by pressing the CapsLock
key on the keyboard. Deactivate the mode the
same way you activated it.
Scr Lk Indicator
The Scr Lk indicator tells you when you
are in scroll lock mode. You can activate or
deactivate the scroll lock mode by pressing
the Scr Lk/NumLk key. Deactivate the mode
the same way you activated it.
On
Off
Figure 2-5 Power Switch
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u

POWER ON

Facing the keyboard and display panel,move
the power switch towards the rear of your note-
book. This is the On position. (Figure 2-5.)
When you are done working you can leave your
notebook in Suspend mode, (see pages 44 and
84), or you can turn it off. The power switch
moved toward the front of your notebook is in
the Off position. (See the section Power Off, page
24, for the recommended shutoff procedures.)
C A U T I O N
After turning off your notebook, make
sure that it has been Off at least 10
seconds before turning the power switch
to On. If you do not you could cause a
system error. When you turn on your
notebook be sure you have a power
source. This means that at least one
battery is installed and charged, or
that the AC adapter or the auto/airline
adapter is connected and has power.
23