Advertisement
Table of Contents
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AQUAMAXX TS Series
Summary of Contents for AQUAMAXX TS Series
- Page 1 TS-Series Sulfur Denitrator TS-1 / TS-2 / TS-3 Installation Guide...
- Page 2 Before Assembly Please open the package carefully, and check if there are any damaged or lost parts. We should have: hose (inlet/outlet) / hose holder Main reactor body and lid Additional Parts Needed (sold separately) Pump (with baffle) • Feeding Pump (AquaLifter pump recommended) Inlet filter (with hose and pinch valve) / holder •...
- Page 3 Assembly Loosen the thumb screws. Turn lid counterclockwise to release. Fill the reactor with your preferred media ( we recommend 70% sulfur media and 30% calcium media), but watch out not to fill into the central tube. You can temporarily block the top of the central tube to stop additives from going down the central tube. Wash your additives before you use them.
- Page 4 Cut a suitable length of the included white hose for the inlet and outlet. Connect the feeding pump to the inlet. PUMP DOSING PUMP water outlet water outlet water inlet water inlet Take off the lid of pH probe holder to install the pH test probe DO NOT PULL OUT THE HOSE DIRECTLY How to separate the hose?
- Page 5 To Start Operating Open the flow control valve,turn on the feeding pump. flow control valve (opened) flow control valve (closed) Turn on the reactor pump on for 20-30 minutes or until the water inside the chamber runs clear. Take this opportunity to check for leaks. After several minutes, check to see if water is exiting the flow control valve and flowing back to the sump.
- Page 6 Maintenance It is very easy for the water inlets and outlets to become blocked by the very slow flow rate, please check the water and air inlets and outlets during regular maintenance. water outlet water inlet Replace the media annually or as needed. Replace the filter media of inlet regulary or as needed.
- Page 7 In order to request warranty service, please email us at info@aquamaxxaquariums.com. A purchase receipt is required for any warranty service. Products requiring warranty service must be returned to AquaMaxx. You are responsible for the cost of shipping a warranty claim to AquaMaxx and any damages that may occur during transit.
Need help?
Do you have a question about the TS Series and is the answer not in the manual?
Questions and answers