Advertisement
Available languages
Available languages
TROUBLESHOOTING
Problem:
1) Vanity doors or drawers rub against
another surface.
2) There is an uneven gap between
the doors or drawers and cabinet.
Side adjustment:
Using a Phillips screwdriver, rotate screw (1)
clockwise to move the door left and
counter-clockwise to move the door right.
Moves the door up to 2 mm.
Lever
Drawer slide
Step 1: Release the lever on each drawer slide (push the lever on the left
drawer slide downward and the lever on the right drawer slide upward) to
release the drawer from the cabinet. NOTE: to remove the drawer, hold the
lever in place and firmly pull the drawer out.
Possible Cause:
Floor or vanity is not level.
Depth adjustment:
Using a Phillips screwdriver, rotate screw (2)
clockwise to move the door forward and counter-
clockwise to move the door backwards.
Moves the door up to 2 mm.
Figure 4 - Adjusting Hinges
Drawer slide
Figure 5 - Adjusting Drawer Slides
Magick Woods Exports Pvt. Ltd. Customer Service:
Phone: 1-855-995-5578 • Fax: 905-738-5579 • Email: contactus@magickwoods.com
Corrective Action:
1) Use a shim to ensure the vanity is
level.
2) Adjust the door hinges or drawer
slides. Figures 4 and 5.
Height adjustment:
Using a Phillips screwdriver, loosen both
screws (3) and adjust the mounting plate po-
sition as required to shift the door up or down
+2mm / -2mm. , then tighten the screws to
secure.
Drawer slide
Lever
Screws
Step 2: Using a Phillips screwdriver, loosen both screws that fasten the
drawer slide to the drawer. Shift the drawer slide as needed (up or
down / in or out). Re-tighten the screws and repeat for the opposite side
as necessary. To place the drawer back into the cabinet, align the drawer
slides with the cabinet slides and push firmly until the drawer is secured
into place.
Drawer
front
Advertisement
