Advertisement
MAINTENANCE
CLEANING YOUR WINE COOLER
• Turn off the power, unplug the appliance, and remove all items including shelves and rack.
• Wash the inside surfaces with warm water and baking soda solution. The solution should be about
2 tablespoons of baking soda with a quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning area of the controls, or any
electrical parts.
• Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a
clean soft cloth.
• The door gasket must be kept clean to ensure a proper seal
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of your
appliance if you minimize the number of times the door is opened. If the power is going to be off for
a longer period of time, you need to take the proper steps to protect your contents.
VACATION TIME
• Short vacations: Leave the Wine Cooler operating during vacations of less than three weeks.
• Long vacations: If the appliance will not be used for several months, remove all items and turn off
the appliance. Clean and dry the interior thoroughly. To prevent door and mold growth, leave the door
open slightly: blocking it open if necessary.
MOVING YOUR WINE COOLER
• Remove all items.
• Securely tape down all loose items (shelves) inside your appliance.
• Turn the adjustable leg up to the base to avoid damage.
• Tape the door shut.
• Be sure the appliance stays secure in the upright position during transportation. Also protect the outside
of the appliance with a blanket, or similar item.
ENERGY SAVING TIPS
The Wine Cooler should be located in the coolest area of the room, away from heat producing appliances,
and out of the direct sunlight
WARNING! This product contains chemicals known to
the State of California to cause cancer, and birth defects
or other reproductive harm. www.P65Warnings.ca.gov
6
TROUBLESHOOTING GUIDE
You can solve many common appliance problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance does not operate.
Appliance is not cold enough.
Compressor turns on and off
frequently.
The light does not work.
Moisture forms on the outside.
Moisture forms on the inside.
Vibrations.
The appliance seems to make
too much noise.
The door will not close properly.
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
Check the temperature control setting.
External environment may require a colder setting.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
The room temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Not plugged in.
The circuit breaker tripped or a blown fuse.
The bulb has burned out.
The switch is in the "OFF" position.
This is normal during periods of high humidity. Wipe dry
using a soft cloth.
The door is slightly open.
This is normal during periods of high humidity.
Door is opened too long or too frequently.
Check to assure that the appliance is level and not touching
the wall.
The rattling noise may come from the flow of the refrigerant,
which is normal. As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your appliance.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The appliance is not level.
The appliance is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.
7
Advertisement
