Advertisement
WINE STORAGE
1. The maximum capacity is 33 wine bottles (25.6 oz/750 ml) when placed vertically
as shown in Figures A, B and C.
2. In order to achieve the maximum capacity, arrange the 7 bottles in top rack as shown in Figure A,
arrange the 5 bottles in next four racks as shown in Figure B.
OPERATING INSTRUCTIONS
• Adjust the temperature by using the up and down arrows to various settings.
The temperature range is 39 °F to 64 °F (4 °C to 18 °C).
• Touch the up arrow (
) and the temperature will increase 1 °F (1 °C).
• Touch the down arrow (
) and the temperature will decrease 1 °F (1 °C).
• The new desired temperature will flash on the display for five seconds and then
back to the actual temperature which will gradually change until the set point is reached.
• Touch the "°C/°F" and the temperature display will switch between °C & °F.
The suggested temperature range for red wine is 53 °F to 61 °F (11 °C to 16 °C).
The suggested temperature range for white wine is 43 °F to 50 °F (6 °C to 10 °C).
4
REVERSING DOOR
NOTE: Do not tilt the appliance over 45 degree when reversing the door as
possible damage to the sealed system may occur.
1. Remove top hinge cover and 3 top hinge screws which are below it. Then remove top hinge.
2. Remove 1 cabinet plug and 1 door handle plug.
3. Remove the door.
4. Remove right and left leveling legs.
5. Remove the bottom hinge and 3 bottom hinge screws.
6. Install the bottom hinge on the other side of the leveling legs with 3 bottom
hinge screws.
7. Install right and left leveling legs. There are two holes below the wine cooler to fit
the two leveling legs.
8. Install the door.
9. Install the top hinge on the other side with 3 top hinge screws.
10. Install top cover above the top hinge and install 1 cabinet plugs on the
11. Adjust the leveling legs.
1. top hinge cover
2. top hinge screw
3. top hinge
4. cabinet plug
5. bottom hinge
6. door handle plug
7. bottom hinge screw
8. leveling legs
5
Advertisement
