Advertisement
Quick Links
HOMESTEAD PERGOLA
ASSEMBLY INSTRUCTIONS
These instructions are for the smooth -finished cedar model. If you purchased the
rough-sawn cedar model, method of assembly will be very similar but may differ
slightly.
Shown: 12'x14' Freestanding Cedar Homestead Pergola
Advertisement
Related Manuals for Pergola kits USA HOMESTEAD PERGOLA
Summary of Contents for Pergola kits USA HOMESTEAD PERGOLA
- Page 1 HOMESTEAD PERGOLA ASSEMBLY INSTRUCTIONS These instructions are for the smooth -finished cedar model. If you purchased the rough-sawn cedar model, method of assembly will be very similar but may differ slightly. Shown: 12’x14’ Freestanding Cedar Homestead Pergola...
- Page 2 Thank you for purchasing the Freestanding Pergola. Depending on the Homestead size of the pergola, installation can usually be completed in a day. There are a few things you should consider before installation: 1.) Do not store the Pergola components in direct contact with ground concrete, or other moisture wicking surface as this may warp the components.
- Page 3 them so that they are positioned in the used to ma them so that they are positioned in the used to m approximate location of where the pergola the 2x4 boa approximate location of where the perg the 2x4 b will be.
- Page 4 dimensions MUST be the same. Adjust the tem pergola to a wood deck, use a 4” lag bolt (not included) instead of a wedge bol until the diagonal measurements are identical. 5. Once the template is “square”, mark the pos locations using the INSIDE corners of the frame on a concrete slab with a pencil.
- Page 5 Setting the Posts Post Bases 8.) Now you are ready to install the Post 7.) Attach all the posts to the bracket using (5) Bases, trim rings, and center rings. Get a 2 ½” screws per bracket. ladder and slide the base over the top of the post (see above).
- Page 6 SECTION 2 – SETTING BEAMS The instructions moving forward are the same whether a floor was ordered, or not. NOTE: Because the beams can be quite heavy, it is a good idea to have at least 2 people to hold the beams on the posts while a third person attaches them.
- Page 7 12.) When both return beams are installed, Anchor remaining Posts to Concrete fasten both header and post to return beam 13.) Sliding the base up towards the top you using (2) 8” GRK screws. Continue this step can fasten it to the post with a screw to keep for all four corners.
- Page 8 SECTION 3 - TRIM Attaching the rest of the trim Fasten Center Trim 14.) Slide the trim ring up against the beam 15.) It does not matter where the center trim and return beam. Fasten with (2) 2 ½” screws is placed.
- Page 9 SECTION 4 - SETTING RUNNERS 16.) Position the runners with the notches over Setting Top Runners the markings on top of the beams. Fasten with 17.) Top runners are to sit on top of the main runners, in much the same way that the runners (4) 2 ½”...
- Page 10 P a g e | 10 18.) Install U-shaped trim on outside out post. A U-shaped piece of trim is included that will ped piece of trim is included that will cover the cover the tops of the posts, and also hide the s, and also hide the ends of the lag bolts.
- Page 11 The Oasis Pergola is now complete. Be sure to call your project advisor with any questions. If you purchased a canopy with your pergola, follow the directions that are included with the canopy. ENJOY YOUR NEW HOMESTEAD PERGOLA...